BCM400 Flashing

[morgansdad]

I have a BCM400, that was rls3.0. Upgraded to 3.6 and then to 3.7. At rls 3.0 the lightsLEDs on the front of the BCM would flash until rebooted and then a day or two later they would start flashing again, the BCM is functional. I thought that upgrading to 3.7 and patching the BCM would fix this problem, and it hasn't. Also, there aren't any alarms in the logs.....From what I can tell. Any ideas?

 

[senk1s]

You are probably looking at a faulty BFT (base function tray) and potentially bad MSC as well

Get hold of your vendor and get it checked and replaced.

Meanwhile do a backup of all programming if not already done - that'll come in handy