BCM400 central leds flashing & no management access 1

[charteng]

I have a BCM400 that survived a power cut and restoral, and now has the MSC/WAN/MODEM/NIC1/NIC2 leds flashing continuously. The HDD led is off and the status led is flashing. The caps on the base board are blue..so the green thoery is out.
I have no access to system via NIC1 or 2, no access via the serial port and most suprising nothing from the onboard monitor/keyboard/mouse ports. But the system is happy to boot up and direct calls to extentions, but alas no CallPilot / Voicemail.
Reading through the forum notes and ... the manual .. the leds give an idication of base board failure , disk controller failure or just hard disk failure.
I mainly support Panasonic and BCM50's so I am looking for a little guidance please on whether I am on the right track or I have missed something obvious..... cheers

 

[curlycord]

Best to post in the BCM forum for best/more answers as this is Norstar forum.

http://www.tek-tips.com/threadminder.cfm?pid=1361

Off the top sounds like hard drive failure since the HDD is not lit and the CP resides on the hard drive where phone system is on flash drive.




=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[charteng]

Many thanks for the guidance, I have reposted in the suggested section.... cheers