BCM400 and BCM50 networking

[DigitelD]

I have a BCM400 4.0 and 2 BCM50's that I am networking using VOIP over VPN. I can call from the 50's to the 400 but I cannot call the 50's from the 400 & I cannot call from 50 to 50. Here are my settings:
50-1 has DN's 4000
50-2 has DN's 3000
400 has DN's 5000
Routing has been set up in each BCM for each BCM. For example, in 50-1: Destination code 4A & 5A use route 001 which uses BlocA which has the VOIP trunks in it.
I have remote gateways setup in each BCM for each BCM. I am using GW type BCM and GW Protocol is None. I have the Default Gateway on each BCM as the normal Default Gateway for the LAN.
I have target lines programmed on each test phone with all settings correct.

When I try to dial from the 400 to the 50's or from 50 to 50, it just sits there and does nothing.

I am clueless at this point.


SHK Certified (School of Hard Knocks)

 

[DigitelD]

UPDATE: I finally got it working with some minor changes. However, I do have one question. Why do I have to put my received digits in the Public recieved field to get it to work. Everything works great now but when I remove the Public leaving only the Private it will not work.

SHK Certified (School of Hard Knocks)

 

[biv343]

You need to have the MCDN keycode on the system in order to have the "private" number field work.

 

[DigitelD]

That is where my confusion has been. Let me ask you another question, do I need to make the default gateway of the 50's the IP of the 400?

SHK Certified (School of Hard Knocks)

 

[MagnaRGP]

Unless all of the devices are on the same subnet, the default gateway on each BCM should be the gateway of the network that it resides on.