BCM

[FDproductions]

I don't know if this is the correct forum for this, but where can i get the Unified Manager for the BCM (the program that programs the BCM). Or at least where can I look.

Thanks

 

[MarvO1]

It's built into the BCM. Just point your web brouser to the IP address plus port :6800 you have set in your BCM.
Example: 10.10.14.17:6800.
Documentation is also built in.

MarvO said it

 

[FDproductions]

Thanks for the input. Is there going to be a password that i will have to know?

 

[MarvO1]

Yes, but it is dependent on which software release you are working on. 1.0, 2.0, 2.5, 3.0 or it might be changed from default.

MarvO said it

 

[FDproductions]

ok, i finally was able to check out this BCM. It is a BCM 200 that is not connected to a network yet. It has a 16 port module in it for digital extensions.

I am very familiar with nortel programming, but accessing the BCM (when not on a network) and getting into programming is my problem. Any help.

Thanks

 

[MarvO1]

You can do a serial connection to it to set up your networking parameters, then just use a cross-over ethernet cable from your pc to the LAN card.

Complete procedure is way too intense to try to post through a forum.

MarvO said it