Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM 1

Status
Not open for further replies.

kkatt

Programmer
Dec 31, 2013
4
US
Trying to familiarize myself with the BCM programming. I need to do old DN new DN on some phones. On the MICS not an issue for me but I cannot find the programming in the BCM. Are you able to do this on a BCM? Right now option not available to change patch cords cannot get to the jacks to identify. Have all the target line programming and capabilities info. Just cannot find where to do this on a BCM 400. Any help would be appreciated.
Thank you
 
3 ways
-Look at the list of sets under active sets and change the DN where you see it
-Look under General/Change DN or Configuration/Change DN...cant recall now.
-Get the port number of the sets and swap them at the point of termination (end of amp cables)




=----(((((((((()----=
curlycord

small-logo-sig.png

Toronto Canada
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top