BCM to BCM on cisco switches

[nortelneo]

hi,
I have a site A with BCM400 connected to a BCM450 at a remote site B over h323. We upgraded our switches at site A to cisco3560 with 10GB uplinks,(all on the default vlan1, similar to how it was earlier). Now calls from A are not going to B. But calls from B are coming to A. Our PRI lines are at site A, and calls are not able to connect to the users at site B when dialed direct.
The only changes to the network were the switches. All the IP's are pingable at all ends.
Where should I begin troubleshooting? Appreciate any help.

Regards.

 

[norstarboy125]

They are called FMFM, log into EM-System-Keycodes-If you have any you will see them listed with the rest of your codes.

Charm City Communications

http://www.charmcitycommunications.com

 

[nortelneo]

Hi,
It's working now. There was a duplicate entry '2', in the routing table. Nothing to do with the network switch upgrade. Thanks.

 

[norstarboy125]

Sorry responded to wrong thread.

Charm City Communications

http://www.charmcitycommunications.com