It's been three weeks but just happened again. Customer has BCM ( just upgraded to feature pack 1 maint. rls 1 ) PRI : b8zs NI2 , experienced "44" error on set. incoming is fine, takes a reset to get outgoing back. Network finger pointing for 4 months. Prior to this experienced almost every weekend. PRI obviously bouncing outgoing never comes back up.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM PRI "NO OUTGOING"
- Thread starter BCSDAN
- Start date
My BCM programming is a little rusty, but you can check to see if there is a business name programmed under general settings and clear it. Ive seen this happen on Norstars with a business name programmed. Also check the OLI# under line access, and clear it out if theres anything there and try it. It sounds like the BCM is configured properly otherwise.
Good luck Kevin Clear
Clearfield Comm.
Good luck Kevin Clear
Clearfield Comm.
- Status
Similar threads
