BCM/PRI QUESTIONS

[dcommusa]

I have the following questions on ordering a new PRI for a BCM 400.(going from analog-copper to pri)

1.National or custom?
2.Ascending or descending?
3.Call by call or dedicated?
4.How many digits do you usually have co send?
(changing main # from copper to did on pri)
5.Can DTI module go in any open slot in BCM?
(This would save us from pulling out analog/copper
modules & we can turn up pri be-fore we have #'s ported.)

Anything else you can think of when ordering/installing?

Thank you !!!

 

[biv343]

1. NI2.
2. You can configure either way. Ascending is common.
3. Not exactly sure. You can dedicate channels as inbound or outbound only. I'd have them leave the channels as two way in or out.
4. Four or Seven
5. As long as it's on an available bus and in the BCM 400 main cabinet, not the expansion cabinet.