BCM ISDN with digital trunk interface 1

[handley88]

I need to move a bcm50 with a digital trunk interface setup on isdn 30 but at the other side they have 3 isdn 2 lines.

I looked at the nortel site but they don't really talk about multiple isdn lines.

Thanks

Alex

 

[Khosher]

You will need to replace you DTM Media bay module with a BRI module, below is the part code you will need

NT7B76AAAHE5 EE--BRI S/T-BRI MBM

 

[Khosher]

You will need to replace your DTM Media bay module with a BRI module, below is the part code you will need

NT7B76AAAHE5 EE--BRI S/T-BRI MBM

 

[handley88]

Thanks for your fast reply. Will this require much reconfiguration ?

 

[Khosher]

A little not too much, you will need to change the module type in telephony resources and provision the lines you plan to use on the module, you will need to assign the BRI lines to a new line pool, give your DNs access to this pool and adjust your route to point to the new line pool.

Also if the DDIs are different, you will need to reprogram your target lines.

 

[handley88]

Thanks that's great

 

[Khosher]

No probs at all