BCM IP Set up

[killbox]

2nd post here. Again, new on the BCM.

Is there anyway to have more than 2 IP Set up on a BCM400 release 4.0? As I see, you can only use 1 LAN port to route all IP traffic over? Is that right? Can't you route VOIP trunking over 1 and IP sets over another?

Also, is VPN the only way to make IP work? Is there any way around the One to One NATing?

Thanks,
Killbox

 

[biv343]

Only one LAN port can have IP traffic pass through it.

Certain firewalls support cone NAT which gets around the one way audio issues typical with NAT devices. The real question is why would you put your companies phone system exposed to the Internet without any security? VPN is the only secure way to go.