Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM H323 with Multi Tech MVP 410
- Thread starter coneill79
- Start date
- Thread starter
- #3
For simplicity of describing what I am attempting. I want the Multi Techs to act as an ip gateway to my 2 remote sites; same as you would with a norstar gateway except the remote ends are partners. I am confident with configuring the dial plans because I had it set up before with the 2 Multi Tech Modem and it worked great. The Static end acted as the IP registrar and the dynamic end resolved to it every few minutes. I am now placing the BCM at the static end and using the Multitecs at 2 different dynamic remote locations.
What I need to accomplish is to:
1. Have the BCM communicate with the Multi Techs and from what I have seen so far from the BCM is that I am forced to use H323 which is fine as the multi techs can do H323 but I can't seem to accomplish this.
2. I need the BCM to act as the registrar in order for the remotes to resolve to it due to the fact they are dynamic.
What I need to accomplish is to:
1. Have the BCM communicate with the Multi Techs and from what I have seen so far from the BCM is that I am forced to use H323 which is fine as the multi techs can do H323 but I can't seem to accomplish this.
2. I need the BCM to act as the registrar in order for the remotes to resolve to it due to the fact they are dynamic.
- Status
Similar threads
- Question