BCM digit management

[molttbe]

Hi, all

I am setting up VOIP between ITG and BCM.
If i used access code for VOIP line(Pool n), i could connect ITG's site. After delating access code and then creating destination code, i could not conect.

I'd like to manage outgoing digit from BCM as if DMI in Meridian 1.
is it possible to insert and delate digits before outgoing digit from bcm ?

if so, please, let me know.

JJY

 

[biv343]

You can do a "crude form" of DMI on the BCM, but nowhere near as clean as it can be done on the Meridian.

You would need to build a different route pointing to pool N, configure as private (assuming you're dialing "on net" so to speak). The external number field in the route is where you can add digits to the numbers that are sent across that route.

If you are dialing extensions 44XX, build a destination code for 44, point it to the route in question, absorb whatever needs to be absorbed, then point it towards the route you created that inserts any digits that need to be inserted.

 

[molttbe]

Dear biv343
Thanks for your response.

Actually what i want is delate digits.
There are more than 2 sites of ITG, and each ITG's site has only 4 didit's extensions without Loc code.
From BCM to ITG, i could connect only one site.
M1's site has almost same extension range from 1000 to 8999.
I'd like to connect to 2 sites.
That means front digit should be delated. Of course, front digit is for site 1 or site 2, and all digit should be sent to each ITG's site except front digit.
is it possible? if possible, please, let me know.

JJY