BCM config

[IBRAHIMO]

i am trying to install BCM with DTM MBM and 3 DSM32+
i put the dip switch settings as follow :
for the DSM32+:
off on on on on on
off on on on on on
off on on on off on
this double dinsity settings to start from Bus02
the DTM as follows :
on on on off on off
to start from bus 07
thr split is 2/6
the problem is when i log into the system to the MBM it shows that Bus01 is equiped with station mbm and all other Buses are unequiped.

please if anyone can help ?

 

[biv343]

Don't have the switch setting info in front of me, so I'll assume you're putting your DSM's on bus 2,3 and 4. Bus 1 is not configurable - bus 2 would be your first DSM 32+. Bus 2 defaults to a trunk module. Make sure you go under Resources, Media Bay Modules and configure bus 2,3 and 4 and set them as a station module. Same for bus 7 - set it as a trunk module, then set your protocol/clocking as well.

 

[gecko202002]

Assuming that your BCM is a newer revision and can take the double density then:
Bus 2 is correct: off on on on on on
Bus 3 needs to be: Off on on on on off
Bus 4 is correct: off on on on off on
Bus 7 is correct: on on on off on off
Change the module type as Biv states, then plug a telephone in on each module - sometimes the station modules do not show as equipped until a telephone is attached.
You might also need to disable then re-enable Bus 7 for it to show the proper module type.

 

[acewarlock]

you must have at least 1 phone plugged in to make the 32+ active.