BCM 50 w/Cisco 2900

[auburn24]

Does anyone have experience setting up a BCM50 thru a Cisco 2900 switch? I am trying to set this up on our bench so I can test the IP phones. I have all of the keycodes loaded, the digital and analog phones are working.

I am configuring the BCM using the Manager and the 2900 using the web GUI (instead of telnet). I have VLAN0002 set up for voice, the BCM is plugged into port 1 on the 2900, the phone is plugged into port 2. Both are set with QOS.
The IP for the BCM is 192.168.1.2...the 2900 is 192.168.1.4.
I have solid green lights on both ports 1&2...but the IP phone (i2004) will not connect to the server, keeps timing out.

Anything obvious I am missing? Any help would be appreciated.

Thanks,
Chad

 

[MagnaRGP]

Did you set the phone to recognize the VLAN?

 

[exsmogger]

I'm not sure about the BCM 50, but in our BCM 200 I had to set the next hop route to get a remote IP phone to connect to the server. This is the gateway IP and should be 192.168.1.1 in your scheme.

Brian Cox

http://www.jandjcommunications.com

 

[madwok]

Are the BCM and the IP sets are one the same VLAN ?
How the IP sets get its address ( fixed or DHCP /full/partial ? )
Did you config IP set with correct S1, port # matching the BCM?

Can you ping the IP sets from the BCM ?

 

[senk1s]

Is IP Phone registration enabled? (with/ without password)
try automatic assignment

If the phone and bcm are in different vlans ...then the def GW should be a router 'connecting' the vlans