Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM 50 Reset 1
- Thread starter nbowles
- Start date
-
1
- #2
You can do a level two reset - page 166 of the BCM 50 documents. If you don't have access to the docs, here are the basic steps:
1. Boot system. Wait for power LED to flash yello, status LED solid yellow.
2. Press Reset switch. Power LED will be solid red, status LED flashing yellow.
3. Press reset switch again within 5 seconds. Power LED will be solid red, status LED will be flashing red.
4. Wait 5 seconds, press reset switch one last time. Power and status LED's will be solid red.
The system will return to "out of the box condition" within approximately 20 minutes. Note that you will lose any/all programming in the system, will need to re-enter keycodes, etc.
1. Boot system. Wait for power LED to flash yello, status LED solid yellow.
2. Press Reset switch. Power LED will be solid red, status LED flashing yellow.
3. Press reset switch again within 5 seconds. Power LED will be solid red, status LED will be flashing red.
4. Wait 5 seconds, press reset switch one last time. Power and status LED's will be solid red.
The system will return to "out of the box condition" within approximately 20 minutes. Note that you will lose any/all programming in the system, will need to re-enter keycodes, etc.
- Status
Similar threads
