BCM 50 R5 H.323 IP trunk to BCM 450 R5

[cdhende]

I'm really new to all this and at this point lost. I have a BCM 50 R5 and a BCM 450 R5 and I need to set up the IP trunk connection using H323. I have the following programmed on both.
BCM 50
Resources/Telephony Resources/IP Trunks:
to BCM 450, Destination Digits: 2, IP: xxx.xxx.xxx.xxx, GW Type: Other, VOIP Protocol: H323
Telephony/Dialing Plan/Line Pools
Bloc B - set up with BCm50's extensions
''/''/Routing
Dest Code: 9, Normal route: 001, Absorbed length: All
Route: 001, Use Pool: B, DN Type Public

I have the same information for the 450,except with it's information.

The first thing I notice is when I dial the 9, I get "Denied in admin" on both the 50 and 450. I'm sure there are a multitude of other things I either haven't set or have set up wrong. Any assistance would be greatly appreciated.

Thanks

 

[oldestgeek]

Start by going to each set and add BlocB to the line pool access. Use BCM Monitor to test and see the call progress on each box. That way you can see the sent digits, etc.