BCM 50 Nortel Factory Mode

[levisp]

Hi All

I resetted a BCM 50 to second level reset (Nortel Factory Mode), Does any know how to recover the BCM to normal mode?

Rergards,

Levis

 

[biv343]

Level 2 reset is a factory default - you would need to reprogram and re-enter keycodes, or restore from a known good backup.

 

[levisp]

biv343

The status led and the power led are flashing in red, The BCM doesn`t boot, The BCM manual tells that the Nortel factory mode must not be used

Regards,

Levis

 

[biv343]

When both LEDs are flashing red, you should just need to press the button again to complete the reset. If both lights are still flashing red after a reboot, then you should contact your vendor or Nortel.

 

[option11newby]

Levi,

I had exactly the same issue, had to have the unit replaced by Nortel.

Regards