Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM 50 Modem set up?

Status
Not open for further replies.

Arr

Vendor
Oct 24, 2001
1,682
CA
Does anyone know how to get remote access to a BCM 50 using a DID and the internal modem?

PhM


VVV
 
Too detailed to list.
Check the BCM 50 Networking Configuration Guide for the details.
Always RTFM (Read the friendly manual)first.

SD
 
SD,

RTFM'd myself to death on this POS. Too bad it's soo complicated. Even the manuals for the M1 are better. And as for element mangler....

Anyone else?

PhM



VVV
 
In themodem Tab field under Resources, put a tick in the 'Enable modem' box at the top.

On the right hand side where it says line, insert the Target Line number which carries the DID.
Just below that, remove the check from Auto Disable modem.

Create a dialup networking connection to the DDI number, entering the respective username and password.

When connected, Launch Element Manager and connect.
 
O11Newby,

Thanks. Got it before I read your post. It was the PC end that was not clear.

Note for others: the password in your dial up connection should be the same as your assinged password for the IP address (default at the PC end 10.10.14.1) used in excrement mangler.

My connection through modem is just about as fast as on site by LAN and it's been solid for 40 minutes so far.

Cheers
PhM



VVV
 
Ace,

No, an OLD laptop with a slow processor.. at least by today's standards. The mangler interface is a HUGE program. I've kept my laptop all these years because it does a great job of talking to M1s with an old DOS program. Program has a nice split screen where I can view the cache and current info at the same time. Don't want to give it up.

Don't think my patch took last night system timed out after an hour and disconnected. This morning the time on the system was stuck at just after midnight.

Cheers
PhM


VVV
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top