Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM 50 Cutover from AT&T PRI to TWC PRI 1
- Thread starter RayBob
- Start date
-
1
- #2
What you SHOULD expect is nothing. It should be absolutely seamless and have the whole thing take about 10 minutes.
HOWEVER
What you CAN expect is that the PRI will not come up and they will blame the BCM, telling you that you have defective hardware, incorrect programming yada yada yada.
Just make sure that your interface is set correctly and your protocols are set to match what they expect.
NI-1 (labelled as DMS100 in the BCM) or NI-2
ESF
B8ZS
Clocking set to Primary External
Port your numbers
Outside of that, there isn't much more to it.
Let us know how it goes.
HOWEVER
What you CAN expect is that the PRI will not come up and they will blame the BCM, telling you that you have defective hardware, incorrect programming yada yada yada.
Just make sure that your interface is set correctly and your protocols are set to match what they expect.
NI-1 (labelled as DMS100 in the BCM) or NI-2
ESF
B8ZS
Clocking set to Primary External
Port your numbers
Outside of that, there isn't much more to it.
Let us know how it goes.
- Status
Similar threads
