BCM 50 BRI S/T Interface (BRIM)

[ansellrk]

Previous post thread1361-1106867

I have the same problem on a new 'out of the box' BCM50. I have configured as per instructions but the status of the MDM is Enabling... not moving onto Enable. Any ideas what could be causing this problem?

Thanks

Rob

 

[biv343]

Dip switches on the module are all in the default positions (on)? Expansion cabinet keycodes are present? Expansion cabinet is plugged into the correct port?

 

[ansellrk]

Yes, Yes, Yes!

 

[subx]

Mostly its about the DIP Settings.. Make sure all are set to "on"... also check that u are using the "right" port for & on expansion cab ... keycodes missing!? Whats the status of the led on MBM?

 

[ansellrk]

OK. ALL DIP Switch settings are ON. I am using Port 2 for the Expansion Cabinet. Keycodes have been installed and show 1 Expansion Cabinet allowed. Status LED's are both Green. I have a live ISDN cable plugged into Loop 1 but no green light appears. Meanwhile, the Internal Trunks, Internal Sets & Expansion CAB are all on "Enabling" (I have set the Expansion CAB to BRIM and enabled it and provisioned Loop1 and both lines.

 

[subx]

What port did u use on the expansion module? did u try "hotplugging"? Sometimes its needed to do that without enable/disable.... did u try to change it to Loop and back to BRIM or something like that?

 

[ansellrk]

I used the + port on the expansion module. I have tried "Hotplugging" and tried changing it to loop and back to Brim... still no joy

 

[biv343]

When in doubt, try a cold start of the system. That might wake it up.

 

[ansellrk]

Tried several cold starts...even did a level 2 reset!