BCM 50 BRI Module Problem

[Egghead2]

Hi,
I have a BCM50 with 1 expansion module and a BRI S/T module plugged in. The DIP switch settings are all ON as per instruction. The problem I have is the STATE of the module stays at "Enabling.." and does not goto " ENABLE ". I have checked the programming and all looks OK.
Can anyone help????

 

[3Sixty]

What sort of BCM 50? Have you got all your keycodes entered?What port have you the expansion cabinet connected in?

Marshall

http://www.marshallshouse.co.uk

 

[kirchenlo]

I had soemthing similar with BCM, but a 400 platform and in my case it was the BRI module

LKI

 

[kirchenlo]

Hardware Fault

LKI

 

[3Sixty]

Check you have diasabled the correct amount of loops on the circuit. This sometimes stops the module from coming up. If you have 4 lines deprovision 503 and 504 and see what happens.

What LEDS are lit on the BRIM module?

Marshall

http://www.marshallshouse.co.uk