Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM 50 and CS1000M rls 4 IP Peer

Status
Not open for further replies.

lexer

Programmer
Jun 13, 2006
432
VE
I´m trying to connect a BCM 50 rls 1 and CS1000M Rls. 4.0 (Small System-11c) using IP Peer, I could make the BCM to register in the NRS, But when I try to call from BCM to any extension in CS it tells me "Network Unavail 47".
When I call from the CS1000M to BCM, I see that that I take the IP trunk but I doesn´t appear the gateway IP adress, here a trace:

ACTIVE TN 001 0 00 11
ORIG 001 0 00 11 0 SCR MARP 0 226 3902
TERM 064 0 00 01 V PHYSICAL TN 008 0 00 18 IPTI RMBR 4 2 TXTSAP: 0.0.0.0
PORT: 0 CODEC: 32 H.323 ENDPOINT IP: 0.0.0.0
DIAL DN 600
MAIN_PM DIAL AUX_PM COMPLETE
TALKSLOT ORIG 25 TERM 57
EES_DATA:
NONE
QUEU NONE
CALL ID 0 354


AUX NARS



---- ISDN ISL CALL (TERM) ----
CALL REF # = 4385
BEARER CAP = VOICE
HLC =
CALL STATE = 3 OUTGOING
CALLING NO = 226 NUM_PLAN:pRIVATE TON:ABBREVIATED ESN:CDP
CALLED NO = 600 NUM_PLAN:pRIVATE TON:ABBREVIATED ESN:CDP

In the BCM a set up the following:
*In routing: Number "2" takes rout 001, route 001 (type private) takes Pool BlocB, I`ve got 2 Ip trunk in Pool BlocB
*In Telephony resources I`ve go the following: Fallback: Disable, Call Signaling Gatekeeper resolved, Call signaling port 1720, Ras Port 0, Enable H245 tunneling, Primaty Gatekeeper IP, Alias name= NAME:BCM50NAME

In The NRS I've got the following:
* A CDP 6 that goes to IP trunk rout
* The BCM appears as registered
* I defined Domain, UDP; CDP, Gateway Endpoints, Route entry.

Any idea?
I dont know If I`m missing something?

 
instead of CDP or UDP try (No Change) or none. I cant remember the exact prompt. Also is your BCM set up as SRG or are you just networking them together.
 
Thanks for your answer, I`m using a LAN Network to interconect the BCM and the CS trough IP peer (Ip Trunk)
 
You mentioned that the BCM looks like it is registered, but you didn't mention anything about the CS1000 node being registered. You need that built as a gateway endpoint as well. You are somewhat registering the node to its own NRS server.

Hope this helps
Rob
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top