BCM 50 and Card Dip Switch Settings

[backnine]

The card dip switch settings seem to be different on a BCM 50 compared to a BCM 1000,200,400. I looked on the BCM 50 Disc and was unable to find the dip switch settings. Can some one tell where to get the dip switch settings on the BCM 50.

 

[senk1s]

on a bcm50 system - leave the dip switches to default
the card is supposed to autoconfigure the bus

 

[Crowd36]

You only need to set the DIP switches on a GATM module. The settings are country-specific.

 

[DigitelD]

You don't change the dip switches on the MBM's for the BCM50 except the GATM in certain places. You go into Element Manager and configure what MBM you have in the expansion cabinets.

 

[senk1s]

good catch crowd36, digiteld

the GATM have 2 sets of dip switches ...one for the bus and one for the country/region