I have a BCM 450 and 50 connected via h.323 trunks. I can call the BCM 450 from the BCM 50 with no issues but cannot complete a call from the 450 to 50. I can see the call get a VOIP trunk thru 450 BCM monitor but call never reaches BCM 50 trunk thru BCM monitor. Any ideas ? I have check IP address's and port 1720 in router is there any other ports I should check?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Westi on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM 450 to BCM 50 h.323 fails
- Thread starter 56BelAir
- Start date
- Thread starter
- #2
- Thread starter
- #4
I can ping from system to system and complete calls from BCM 50 to BCM 450 but not vise versa, however I do see the 450 grab VOIP line 1 and dial the digits but the call never completes to the BCM 50.
Looks like a network issue to me but I have the customer states he is wide open?
Looks like a network issue to me but I have the customer states he is wide open?
oldestgeek
Technical User
Do you see a line in the 450 go busy at the same time one in the does? Do you have target lines configured and assigned?
- Thread starter
- #6
No, the line does not go fast busy it actually is trying to make the call for several seconds. I do have target lines as I can make and recieve calls between other BCM's on the network.Only the 450 installed recently has issues sending calls but can recieve no issue.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
