BCM 450 interoffice dialing

[pbxgirltech]

We had tie lines connected from a CS1000 site to this BCM site; but we upgraded the CS1000 to an E and are using sip for most sites now. This BCM does not have SIP trunk, and we removed the tie. I am trying to figure out how to program the BCM to do a manipulation for dialing to other inter office sites via 7 digits. In the CS1000 we use CDP and RLI and DMI to do the manipulations; but I cannot find how to do this in the BCM??? Please assist with details if anyone knows this configuration.

 

[Firebird Scrambler]

You can still purchase SIP trunks for the BCM and this might solve your problem. However it's still possible via the routing table to create a route that is assigned to a number that doesn't conflict and get it to insert leading digits to complete a DID number as I'm guessing that is what you are hoping to do?.


Firebird Scrambler
Nortel Meridian 1 / Succession and BCM / Norstar Programmer in the UK
Advance knowledge on BCM support

http://www.linkedin.com/in/davidbromley