bcm 400 pri interface

[harveystephenb]

My company is transitioning its telephone service from a conventional PRI T1 circuit to a fiber based product from AT& T which uses a router to emulate the carrier-side interface.

What parts of the BCM 400 configuration might need to be customized for this?

 

[curlycord]

Find out from AT&T as to what type of circuit they are providing.
Almost sounds like SIP.



=----(((((((((()----=
curlycord

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[hawks]

If they are going to use the router to emulate PRI then you should not have to do anything. If like curly said they're going SIP then that's a whole new ballgame.

 

[harveystephenb]

The service is to deliver 20 mb over fiber to a router on our premise that delivers "call paths" i.e. PRI bearer channels on its interface to our BCM for voice and remainder of bandwidth by Ethernet for internet. Besides resources > telephony resources > PRI, are there any other PRI related configuration parameters on BCM?

 

[SRC1]

Some routers if the demark is extended by the carrier to a RJ45 a strait cable will work, plugged directly in to the router may require a T1 crossover cable you can find pin out on Google