Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM 400 - No Longer can access 1

Status
Not open for further replies.

dvannoy

MIS
May 4, 2001
2,765
US
We have a BCM 400. I needed to change the ip address of the BCM so I did. now I cannot access the system at all. cannot ping or use BEM to access it. I see lights on the NIC but cannot find the device at all. has anyone ran into this before?

any help would be appreciated

thanks in advance

 
Did you change both LANS? I always leave one LAN alone. Just for cases such as this. You can alos go in through the puddy interface and change the IP. This uses a direct connection to the DP connector on the BFT panel.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top