Anyone know what information is kept on the MSC, I know the ID is there but how much if any programming is there. We have one that we are looking to move from one system to another system and I was just wanting to know what affect it will have. I have all the keycode information to re-enter once the change is complete.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BCM 400 MSC Card
- Thread starter hawks
- Start date
All the programing relating to your telephony section is held on the MSC card. The system ID can not be moved you need to do a keycode regenration to move keycodes from one MSC card to another. This need to be done on the KRS on the Nortel website.
marshall
marshall
- Thread starter
- #4
- Thread starter
- #6
That's what I was hoping. I have one more question (for now), this will be changed out after hours.
Can I go ahead and do anything such as pre configuring, load any patches, ect. to the new system or should I wait until I change the card before I do anything? Thanks for all the help so far.
Can I go ahead and do anything such as pre configuring, load any patches, ect. to the new system or should I wait until I change the card before I do anything? Thanks for all the help so far.
acewarlock
Technical User
either way will work as long as you do a backup to the Harddrive first. If the new system is where your going to put the old MSC card, then make the changes and do a backup and when you change the MSC the system will restore the MSC data from the hard drive for the Telephony and then you can add the Keycodes backin.
- Status
Similar threads
- Locked
- Question
