Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM 400 CTM8 install

Status
Not open for further replies.

carlosmcse

IS-IT--Management
Nov 17, 2005
67
US
Hi all,

I have a BCM 400 v3.5 with (starting from top module) dsm 32+, dsm 32+, CTM8, Digital trunk interface. I want to replace the Digital trunk interface with a CTM8 or GATM8 (no need for a PRI at this time) do I need to do something special on the BCM to recgnize this card swap? And do i need to do some dip switch changes on the module before installation and is there any initialization on the BCM?

Thanks for any help.

Carlos
 
you will have to change the dip switches before i will see the MBM as a CTM8

Thats not my fastball, thats my hurry up and get by you pitch... Satchel Paige
 
Set the switches the same as the T1 card if it is going to be using the same bus.And in resources under Media Bay Mods
change the bus from pri or T1 to loop.Then the lines will have to be put in a pool,etc.Set access to pool.....
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top