Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCM 400 Base Function Tray 2

Status
Not open for further replies.
hm1

hm1

Programmer
May 16, 2007
68
US
I replaced a Base Function Tray on a BCM 400 3.7. Everything smooth as usual,however, when powered system back-up, only a red powerlight. No fans, msc activity, nothing. I put the old Base Tray back in and still nothing but the red power light.
 
Sort by date Sort by votes
You may have a bad card in your system. I have had a bad DSM32+ card cause this trouble before. Pull out your media bay modules and try to boot it up.
 
Upvote 0 Downvote
I agree, disconnect everything from your BCM to pinpoint the problem. Remember to use the original MSC card on the "new" BFT.

"Its just dial-tone. At the end of the day everyone usually gets to go home.
 
Upvote 0 Downvote
Some of the "New" BFT's being bandied around are refurbs with caps replaced.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jsaad
  • Locked
  • Question
BCM 400 4.0 lights flashing
Replies
11
Views
271
exsmogger
exsmogger
jsaad
  • Locked
  • Question
BCM 400 3.7 vm no light
Replies
9
Views
228
jsaad
jsaad
Watch Out.
  • Locked
  • Question
BCM 400 VM down Can access Element Manager.
Replies
13
Views
331
Smoki
Smoki
BCoo
  • Locked
  • Question
BCM 400 Tel Set Reset PSWD CP
Replies
3
Views
152
curlycord
curlycord
LidLock Technologies
  • Question
BCM 200 R3 Disk Image 1
Replies
5
Views
898
curlycord
curlycord

Part and Inventory Search

Sponsor

Back
Top