endlesswinter
IS-IT--Management
we have installed a t1 a few months ago and now no longer use a GATM 8. I plan to remove the GATM 8 and install an ASM. My question is can I use the same dip swicth setting for the ASM that I had used on the GATM?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
bcm 400 asm install 1
- Thread starter endlesswinter
- Start date
- Status
-
1
- #2
Sure can. If it'a an ASM 8+, you may want to change the switches for double denstity operation. Otherwise, plug-n-chug. Might need to tell the BCM that the bus is now an ASM instead of a trunk module, but it should auto detect that when you power the unit back on after changing the card.
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
