BCM 400 And Aastra CNX Conference Bridge

[ccnet]

Hi, has anyone managed to get the Aastra cnx conference bridge up and running with a BCM 400.
I have one and connecting via E1-E1 doesn't seem to work( no doubt I have some settings wrong) and connecting via IP gets one way speach path from CNX to BCM(it's as if the BCM doesn't know the CNX has answered call)
I just wondered if anyone had any experience of this combination.
Aastra website lists a howto for connecting Meridian1 but I am finding it hard to translate into BCM language

Thanks
Les

 

[3Sixty]

What way have you the DTM configured?

Marshall

http://www.nortelsupport.net

 

[ccnet]

Setup as follows at the moment
Module Type PRI
Lines/loops 1
busy lines/loops 0
Low line 121
High Line 150
Protocol Euro
Clock Source Master
Overlap N
State Enabled


E1 parameters CRC4 on

Lines 121-150 provisioned

I started out by setting clock source to Primary but when I couldn't get the two talking I reset this to master, but I think this setting should be Primary.
Les

 

[3Sixty]

It will depend on how the 2 are networked but I would say one will be the master clocking source and the other is normally the secondary clocking source. Some network topology call it the x end and the y end. But you need one to be the master source and one to be the secondary source.

Marshall

http://www.nortelsupport.net