BCM 400 4.0 routing

[vztech]

I'm trying to figure out how to route calls using one destination code
I built 2 routes
route 2 POTS
route 3 PRI
Destination code of 9
Night First route 2 Second route 3
all the sets are using Night filter (default)
I would like all long distance to use route 3 and local route 2

not sure what I need to do next under the filter to accomplish this

thanks for any insight!

It's only dialtone-VZ

 

[cook1082]

You need more than destination code .It will need to be broke down to 9+1 use route 3 and 9 any out route 2.

 

[acewarlock]

Access Code

91A route 3
92A route 2
93A route 2
94A route 2
95A route 2
96A route 2
97A route 2
98A route 2
99A route 2

 

[biv343]

Might want to route 911 out the POTS lines in case the PRI ever goes south.

 

[acewarlock]

If they dial 9911 in my port above it will go out COT. if they dial 911 it won't go anywhere.

 

[vztech]

Ace & Biv

thanks very much!

It's only dialtone-VZ

 

[vztech]

cook thanks also

It's only dialtone-VZ

 

[AlATD]

ANYONE SEE A RED LIGHT ON THE FIRST LED WHICH IS THE POWER LED ON A BCM 400 4.0 EVERYTHING SEEMED NORMAL PROGRAMMED UP FINE, BUT I KNOW THE LED SHOULD BE GREEN ANY INSIGHT?

 

[endlesswinter]

start your own thread...Please

 

[Crowtalks]

Acewarlock:
I don't know how it is everywhere, but we are required by law to build routing to allow the customer to pick up their sets and dial 911 and reach emergency services.

I first build the specific 911 destination code with 0 absorbtion and point it to the correct route. I then build the less specific destination codes after.

Normally if I'm routing out using only 1 route I build

911 absorb 0
91a absorb 1
9a absorb 1

 

[cook1082]

The power and status LED's on the BCM 400 4.0 are the same as on a BCM 50.Alarm-status