BCM 400 4.0 and Dialogic 2000 media gateway sip

[SCs5thGen]

Has anybody heard of or used the Dialogic 1000 and/or 2000 Media Gateway Series SIP to T1 boxes?
I am currently trying to connect one to my BCM. I have some SIP trunks from BroadVox and this converts it to a T1 interface for the BCM but I get an error light, the circle with the arrow coming into it. And of course I am unable to dial out at that time. I have tried changing the protocls and timing but no luck.

 

[cook1082]

That light would mean no signal.T1.

 

[SCs5thGen]

I new thats what it meant, I was just elaborating. Just hoping somebody has tried this before and could shine some light.

 

[gberger]

Are you using a straight T1 cable or a crossover one?
You might want to try this first.

 

[SCs5thGen]

I am using the same cable from current PRI provider. I will make a crossover cable to see what happens. Thanks.

 

[gberger]

For your T1 cross-over cable here's the setup;

1--4
2--5
4--1
5--2

 

[SCs5thGen]

I forget to reply after you mentioned x-over. It worked and thanks again gberger!