BCM 3.6 dropping calls between PRI tie

[srtelengine]

I just recently took over 2 BCM 3.6's that are networked via a PRI with SL-1 enabled. I can call all extensions from B to A, but when I call A to B only certain DN's will go through. I have no target lines programmed above 300. Also on B I can progam a target with DN(private) and works for a while and then when you call rings once and disconnects. Lines are configured with Control DN same as extension and private to extension, also set as ring only with 2 appearances on sets and 1 appearance on skillsets. Any help would be greatly appreciated and help returned in kind. Thanks

 

[3Sixty]

In the UK we can not network 2 BCMs together because both BCMs will only act as a secondary clocking source there has to be a Meridian in the mix. Have you a Meridian in the network or some other box?

Marshall

http://www.nortelsupport.net

 

[srtelengine]

Here in the states we network them with either PRI, T1 or IP trunks. I acutally think I'm having a resource issue, because the systme is configured 2/6 PDD and should really be 2/6 FDD. We get our clocking from the Primary circuit and then use it for additional circuits.

 

[acewarlock]

You can't transfer a private line to any other phone or do a call pickup. I changed all mine to public.

 

[srtelengine]

I already had them configured as public. I can call from one site a to be but not b to a. Site b also only has a public dn length of 3 and a is 4. I'm going to change b to 4 but then i'm going to have to put all the receive number back into the target lines.

acewarlock and mrmarshall thanks for the help.

 

[srtelengine]

Thanks acewarlock and mrmarsahll, here was the resolution:
1) upgraded the 3.6 to 3.7
2) Installed all patches available and
wahlla it started working.

Thanks again.