Nikos Koulioumbis
Systems Engineer
Hello Team.
I have a raid controller that originaly was installed on a 3.x BCM400 system meaning it was on the NT version of OS.
The question is can i use the controller directly on a BCM400 4.0 system or there is need a kind of firmware update that should have be done
when upgrading from 3.x to 4.0 system?
Would the controller boot a BCM 4.0 disk even if the controller comes from 3.x system?
It is in lab testing environment so not much to risk from telephony side. Just making different scenarios , i still have the BCM virus in my blood as most of you so any ideas will be
much welcome.
Thank you
Nikos
I have a raid controller that originaly was installed on a 3.x BCM400 system meaning it was on the NT version of OS.
The question is can i use the controller directly on a BCM400 4.0 system or there is need a kind of firmware update that should have be done
when upgrading from 3.x to 4.0 system?
Would the controller boot a BCM 4.0 disk even if the controller comes from 3.x system?
It is in lab testing environment so not much to risk from telephony side. Just making different scenarios , i still have the BCM virus in my blood as most of you so any ideas will be
much welcome.
Thank you
Nikos
