BCM 200 3.0

[FDproductions]

i have looked at some of the past threads and have not found any info on my situation so i will ask here.

I have 2 bcm 200 3.0 and they both work, meaning that the telephony applications work. But the problem that i am having on both of them is that i cannot connect to either of them via crossover or serial cables. Luckily i havn't had any major issues where i have needed to get into programming, but i need to now, so i must address the problem.

Any advice? Thanks

 

[acewarlock]

I have answered this question many times. Does Vmail work?

The 3.0 version was installed on many BFT with Bad Cap's on the motherboards.

 

[acewarlock]

Also look at this thread 181-27567

 

[FDproductions]

they do not use the vm at all so i never checked that. Also i could not find the thread that you just listed. Thanks.

Matt

 

[acewarlock]

It' the one just below the one your reading now.

BCM200 3.7 NT locks up every 2 weeks
thread1361-1239215