bc7 SL60

[aastratech]

For those that can remember !!!

is it possible to provide a QSIG connection on BC7 with a TLU76/1 R6A
I can set up the trunks etc and the board is recongised as board id 57 however the card is system blocked???

any ideas, additional info below, card in bpos 1-0-00 rote 7:
BPOS BOARDID INDIVIDUALS SERVICE STATE
001-0-00 57 32 SYSTEM BLOCKED
001-0-10 102 32 ACTIVE

<RODAP:ROU=7;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
7 SL60 H'00000310 H'55440000 H'06400000 NO

<ROCAP:ROU=7;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
7 711000000000 5 3110030000 0 30 128 03151515 111110000031 1111

 

[aastratech]

anyone any thoughts on this....

Do you think BC7 supports TLU76 or should it be a TLU64???

 

[Mpe]

Hi.

QSIG did not exist until BC9.

mpe

 

[aastratech]

Mpe,

any other thoughts on how we can achieve this with BC7.
Customer needs to link to an Avaya VoIP gateway??

 

[testcentre]

Yes it is possible to provide a basic QSIG link on MD110 from BC6.0 onwards but it will only provide for simple call handling with number presentation/restriction facilities. There is no enhanced networking available. Note also that the QSIG is ISO QSIG (Codeset 4), not ETSI QSIG.

i used the following Route Parameters to achieve working QSIG links on a BC7.2.1 MD110 to NEC and Ericsson PABXs.:

BP250
VARC: 00000100
VARI: 00000000
VARO: 16200000

NEAX7400ICS120
VARC: 00000100
VARI: 00000000
VARO: 14500000

Please email ashleylsimmons@optusnet.com.au for additional information.