baystack 350 two port mirroring

[jack57]

Can two ports be mirrored on a baystack 350 10/100 switch? I'm following the port mirroring instructions but I can't seem to make it work. Does the switch need to be on a specific release?

Jack.

 

[dane775]

You should be able to monitor two ports from one.

Try this from the port mirroring menu. Using the space bar to select different modes determine if you want ingress and egress traffic from X and Y ports.

Monitoring Mode: [<-> Port X and <-> Port Y]
Monitoring Unit/Port [Put in the port where your Sniffer is]

Unit/Port X: [tell it the first port you want to monitor]
Unit/Port Y: [tell it the second port]

Then select mirror config complete.

This should work...my code level is 4.2.0.16...not sure if older levels support that or not.