Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Baud rate for internal modem
- Thread starter d1533
- Start date
dagwoodsystems
Programmer
Nice! Your modem was built just before the V.90 standards came in. I KNOW that it supports Bell 212 (and Bell 103). You should have no problem with it whatsoever.
phonesrus is right about the software. You shouldn't have to fudge around in Control Panel or anything crazy like that. WinSPM will initialize your modem for you. If you DO go into Control Panel (and you are running Windows 95/98/ME), please don't check the "Connect only at this speed" box if the bit per second rate is higher than 2400.
Question about your settings? Start WinSPM and choose Settings, then Configure TAPI...(Modems). Pick your modem and follow the prompts.
phonesrus is right about the software. You shouldn't have to fudge around in Control Panel or anything crazy like that. WinSPM will initialize your modem for you. If you DO go into Control Panel (and you are running Windows 95/98/ME), please don't check the "Connect only at this speed" box if the bit per second rate is higher than 2400.
Question about your settings? Start WinSPM and choose Settings, then Configure TAPI...(Modems). Pick your modem and follow the prompts.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question