Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations biv343 on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Backup Exec Pre Command to check tape availability

Status
Not open for further replies.
redenius

redenius

IS-IT--Management
Dec 8, 2008
1
US
Hello,
Is there anyone out there that can help me write a .bat file to run as a pre-command to check if a tape is available 1st and if returned 0 then it will run a backup-to-disk job instead. I am not a programmer so any help in this area is much appreciated.

Thanks!!!!
 
Status
Not open for further replies.

Similar threads

S
  • Question
EMC Networker restore VM from tape , suggest manually labelling a new writable volume.
Replies
0
Views
357
spirit_architect
S
Tom_001
  • Locked
  • Question
How can I get tape list from save set particular
Replies
0
Views
527
Tom_001
Tom_001
anil5555
  • Locked
  • Question
Networker in HA ( High availability ) for DR
Replies
0
Views
491
anil5555
anil5555
Kennymc
  • Locked
  • Question
backup exec
Replies
0
Views
461
Kennymc
Kennymc
Martha_SysAdm
  • Locked
  • Question
Which hardware and software can i consider for Backup and Disaster recovery 1
Replies
3
Views
681
goombawaho
goombawaho

Part and Inventory Search

Sponsor

Back
Top