Hi Guys,
I was wondering if you can give me a hand.
I have a client running BE 8.6(build3878) in a SAN environment using SSO & a 50+ slot library (ADIC Scalar 100 - LTO). Occasionally a backup will sucessfully finish however the tape will remain in the drive instead of ejecting & cause the next backup job to fail. (yes the "eject media after job completes" box is checked).
I dont think its hardware because the entire library has been replaced. I leaning towards the theory that it could possibly be BE or the something in the SAN setup.
Has anyone else out there seen a similar problem??
Any help would be most appreciated.
I was wondering if you can give me a hand.
I have a client running BE 8.6(build3878) in a SAN environment using SSO & a 50+ slot library (ADIC Scalar 100 - LTO). Occasionally a backup will sucessfully finish however the tape will remain in the drive instead of ejecting & cause the next backup job to fail. (yes the "eject media after job completes" box is checked).
I dont think its hardware because the entire library has been replaced. I leaning towards the theory that it could possibly be BE or the something in the SAN setup.
Has anyone else out there seen a similar problem??
Any help would be most appreciated.