ScoobyJawa
Technical User
We are using Backup Exec on NT4 with an HP C155 autochanger, medium is DDS3.
Normally to change one weeks tapes to the next we highlight the media tab, then "media set 1" we then highlight all the tapes shown and drag across to scratch media.
After this we select the devices tab and then right click on the slots tab under the changer and do inventory.
Only its not allow us to select the inventory option.
I've power cycled the system and changer and its no different. I've set Backup Exec to do inventory on start up and it just sits there not doing anything. If I try and clean the drive it fails.
Any ideas?
Thanks
Neil.
Normally to change one weeks tapes to the next we highlight the media tab, then "media set 1" we then highlight all the tapes shown and drag across to scratch media.
After this we select the devices tab and then right click on the slots tab under the changer and do inventory.
Only its not allow us to select the inventory option.
I've power cycled the system and changer and its no different. I've set Backup Exec to do inventory on start up and it just sits there not doing anything. If I try and clean the drive it fails.
Any ideas?
Thanks
Neil.