B5800 gateway shows PRI 24 (UNIVERSAL) despite a-law UK

[pkellow]

Under Lines, Line 5 shows "PRI 24 UNIVERSAL", despite line sub- type ETSI, clock quality network, signalling CPE. The maximum number of channels that can be selected is 23.

Originally the B5800 shipped with a North American profile, with U-Law.

B5800 version is 6.1.22

system->Telephony->Telephony has been changed to A-Law for switch and line.

system->system->locale has been changed to UK English (intended for Sweden, however UK for initial testing only).

Configuration saved.

I expect to see the LINE as a PRI 30 UNIVERSAL, however I only ever see it as a PRI 23 UNIVERSAL.

I've tried deleting the line, removing the module (the PRI-S daughter card is sitting on a phone2 module) with the unit powered off, restarting, and readding the module (power off) however it never recognises the card with 30 channels.

I also tried a simulator and layer 1 does not come up.

Any ideas?

PS at this stage we are running a 30 day grace period as no licenses loaded yet

Thanks in anticipation

regards
paul

 

[hairlessupportmonkey]

its an IP500 basically, but you are better off in the definity forum?

http://www.tek-tips.com/threadminder.cfm?pid=690

ACSS - SME
General Geek

 

[pkellow]

Thanks.

I've sorted it, according to page 172 of the Manager guide:"The IP500 PRI-U card can be configured to support either E1, T1 or E1-R2 PRI line types. To select the line type required,right-click on the line in the group or navigation pane and select Change Universal PRI Card Line Type."

It works off-line anyway, so should be good for this on Monday when I am back in the office.

Easy when you know!

regards
paul