Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
[b]How to Clear a PRI232 error[/b]
- Thread starter motox2
- Start date
The prog code which causes PRI232 is 8A. M1 only supports 1, 2, 3, 4 and 8. 0A is not supported by M1.
Contact the CO to turn off the feature to stop sending DCH message.
0x81 0x01 1 Call is not end-to-end ISDN or may be in-band information
0x82 0x02 2 Destination call address is non-ISDN
0x83 0x03 3 Origination call address is non-ISDN
0x84 0x04 4 Call has returned to the ISDN
0x88 0x08 8 In-band treatment has been applied
0x8A 0x0A 10 Delay in response at the call interface
Contact the CO to turn off the feature to stop sending DCH message.
0x81 0x01 1 Call is not end-to-end ISDN or may be in-band information
0x82 0x02 2 Destination call address is non-ISDN
0x83 0x03 3 Origination call address is non-ISDN
0x84 0x04 4 Call has returned to the ISDN
0x88 0x08 8 In-band treatment has been applied
0x8A 0x0A 10 Delay in response at the call interface
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question