In PC-Regen I entered following:
Source Name: Back Up
System Type: MD110Standard
Source Path: C:\ProgramFiles\...\Back Up\Source
Target Path: C:\ProgramFiles\...\Back Up\Target
Source System: BC12
Target System: BC12
Data Gen , Start , Done
Than I loaded DATA.CMD file from Source Path to WinFiol.
Back up was made but lot of commands from DATA.CMD didn't execute. It gave me reports like COMMAND NOT IN USE or PARAMETAR NOT ASSIGNED, mostly for commands that refers to some features we do not have at our system (e.g. group switch, ip phones etc). I have skiped those lines and continued with further commands.
Is this ok?
Is the back up I made this way sufficient?
Thanks!
Source Name: Back Up
System Type: MD110Standard
Source Path: C:\ProgramFiles\...\Back Up\Source
Target Path: C:\ProgramFiles\...\Back Up\Target
Source System: BC12
Target System: BC12
Data Gen , Start , Done
Than I loaded DATA.CMD file from Source Path to WinFiol.
Back up was made but lot of commands from DATA.CMD didn't execute. It gave me reports like COMMAND NOT IN USE or PARAMETAR NOT ASSIGNED, mostly for commands that refers to some features we do not have at our system (e.g. group switch, ip phones etc). I have skiped those lines and continued with further commands.
Is this ok?
Is the back up I made this way sufficient?
Thanks!