Avaya J139 phone showing "dialing" continuously when dialing to SIP trunk.

[Richard_Harrow]

Hi,

So we have a SIP trunk hooked up to this makeshift-weird-out-of-this-world open source PABX and both the phone and that server are on the same subnet.

What happens is that when the access code is entered and then the number is given, the phone just shows "dialing" and error message or anything.

Funny thing is, if we use a softclient, we can actually see logs showing up on the server, but nothing shows up when dialing with the J139 because it just shows "dialing".

So what could be causing this?

 

[Menniss]

Funny thing is you're not really making much sense, what's the "makeshift-weird-out-of-this-world open source PABX" got to do with anything?

Is there an IP Office in the mix somewhere?

 

[IamaSherpa]

Try to configure the ARS table short code as N;/dial/N/Line ID xx instead of the defaut one