Avaya IP office 500 V2 9.0.5 Watchguard 26 and Avaya 9620C

[Docy]

I am trying to setup VPN phone with a watchguard26. I do not have access to the WG26 as that is managed by the IT department of my client and wont give me access.

The problem I am getting right now is that IKE Phase 2 no response

Phone settings are:
VPN: Enabled
VPN Vendor: Juniper\Netscreen
Gateway Add: Client's Public IP Address
Auth Type: PSK with XAUTH
VPN User Type: Any
VPN User: PhoneUser
Password Type: Save in Flash
User Password: ********
IKE ID: VPN-VoIP
Pre-Shared Key: ********
IKE ID Type: USER_FQDN
IKE Xchg Mide: Aggressive
IKE DH Group: 2
IKE Encryption: 3DES
IKE Auth Alg: SHA-1
IKE Config Mode:Enabled
IPsec PFS DH Group: 2
IPsec Encryption : Any
IPsec Auth Alg: Any
Protected Network: 10.1.1.0/24
IKE Over TCP: Auto

Any help would be greatly appreciated

 

[Docy]

Just want to thank everyone who rushed to help me with this request.

I got it working

 

[hairlessupportmonkey]

Rather than the sarcastic comments, perhaps you could share your experience.

ACSS - SME
General Geek