AVAYA 9621G H323 Remote configuration 1

[ipoman1234]

Hello guys, need help to configure H 323 Remote phones

1. I have installed IPO 500V2 (R 8.1)
2. Forwarded all ports to LAN 1 IP Adress from Public IP
(5060 & 5061, 54000-54500, 1719-1720,80,49152-53246)

3. enabled remote extension from extension and user tab ( enabled Power User)
4.Enabled NAT, H323 Gatekeeper and H 323 remote extension
5. set Public IP under Network Topology
6. Not cleared about STUN (kept as default)( Where to find stun IP as we don't have any SIP Provider?)
7.configured Phone IP as local from remote location IP Address, Call server and HTTP configured customers public IP
but still phone goes in discover mode
please help with the issue

 

[snowman50]

Go on the web and get a stun server address.
Ping the stun server and get the IP address.
Enter the address in the stun server
Run stun server which should open the port on the ipo
You will have to wait for about 2minutes before it populates with info.
Save the info and reboot ipo.

Go to ip phone and set the call server to the static IP address discovered by the stun.
Set http and https to the same address.
Set 802q to OFF.
Save
Reboot phone and cross your fingers.

 

[tlpeter]

I would hire somebody who done this before as you forward just a bunch of ports.
Also you must keep security in mind and i wonder if you did that.


BAZINGA!

I'm not insane, my mother had me tested!

 

[ipoman1234]

Yes as per document these ports are required For H323
So I did the same,
Also used public STUN Server to determine the field values, after pressing on RUN STUN, it only shows thay "STUN SERVER FOUND FEILD VALUES" under Network topology.
It does not populate any data.
And still phones are in discover mode.
To hire some one is not possible in this case
I will really appreciate if you help me to work on this

 

[tlpeter]

You did not read the doc well.
You have two different ranges of RTP ports.
Don't use the default ports if the IPO is connected to the internet.
Yes this is not real security but at least it is an extra step.
Also don't use ports 5060/1 and change these as well.


BAZINGA!

I'm not insane, my mother had me tested!