Avaya 650 Gateways

[mach1tec]

We have an 3 Avaya650 gateways. Power knocked the switch down. Now, when we do a "list configuration all" it show no boards. And even shows a carrier e when we only have a,b,c with cards. We get one carrier green , and once we try adding cards in orther 2 carriers, it kills the one we had in service...Any ideas?

 

[AvayaTier3]

status environment x
test environment x

list cabinet

                               CABINET REPORT

No Layout/     Rack/                          Loc   A     B     C     D     E
    Room        Floor       Building
1   G650                                      1   PN 01

2   G650                                      1   PN 02

3   5-cmc                                     1   PN 03

7   stack                                     1   PN 04
--------------------------------------------------------------------------------
list configuration power-supply 1

                   SYSTEM CONFIGURATION - 655A Power Supplies

            Power Supply           Power Supply               Power Supply
  Location  Serial Number   Make/Model Number        SAP      Firmware Version

  01A00     05R403000836   Power Unit 655A Rev  B 700246671   2.19A
  01A15                    POWER SUPPLY NOT PRESENT
list configuration power-supply 2

                   SYSTEM CONFIGURATION - 655A Power Supplies

            Power Supply           Power Supply               Power Supply
  Location  Serial Number   Make/Model Number        SAP      Firmware Version

  02A00     06R410002360   Power Unit 655A Rev  D 700406135   2.20
status environment 1

                       CABINET POWER SUPPLY STATUS (655A)

Pow  Alm  Temp(F/C)   Hot     Voltage        FAN       Ring Voltage      Input
Loc  Cnt InLet  Exhst Spot  +5   -5  -48   Ctrl Alm Stat Ctrl  Set  Det  Power

01A00 0  73/23  71/22  ok  5.10 5.10 48.8  mid  N   ok   actv  20HZ  Y   AC
01A15 1  -      -      -   -    -    -     -    -   -    -     -     -   -
status environment 2

                       CABINET POWER SUPPLY STATUS (655A)

Pow  Alm  Temp(F/C)   Hot     Voltage        FAN       Ring Voltage      Input
Loc  Cnt InLet  Exhst Spot  +5   -5  -48   Ctrl Alm Stat Ctrl  Set  Det  Power

02A00 0  71/22  71/22  ok  5.10 5.08 48.8  mid  N   ok   actv  20HZ  Y   AC
--------------------------------------------------------------------------------
list configuration power-supply

                   SYSTEM CONFIGURATION - 655A Power Supplies

            Power Supply           Power Supply               Power Supply
  Location  Serial Number   Make/Model Number        SAP      Firmware Version

                           Power Unit 655A Rev 01 700381452   1.12
                           Power Unit 655A Rev A  700246671   2.19A
                           Power Unit 655A Rev B  700246671   2.19A
                           Power Unit 655A Rev C  700246671   2.20
                           Power Unit 655A Rev D  700406135   2.20

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

37 years Bell, AT&T, Lucent, Avaya
Tier 3 for 27 years and counting

http://bshtele.com

 

[Hudson22]

Start by getting the cabinets, power supplies, and IPSI's if you have them up first. Do this by backing out the rest of the cards, then start seating the cards one by one and keep checking that they show up in the system under list conf all. You might run into a card that is at fault by doing this process.
Good luck,
Hudson22